[ssckrp]

Hi ,

I have two 6509 Cisco Switches both are in HSRP with identical config.

Currently all the vlans created are communicating with a single trunk port between the two switches.

Now new requirement is that I need to have two of the vlans to have its own trunk port..

e.g Vlan - 1 to Vlan -5 has trunkport Gb eth 1/48
Vlan -21 trunkport Gb eth 2/2
Vlan-31 trunkport Gb eth 2/3

What commands should i need to use for this.

Current Spanning tree setiing is PVST.

Will this affect the new setup with any loop?

Pls advise.

Thanks and regards

Prabu

[bdesmond-mvp]

Why trunk a port that's only carrying one vlan?

In any case you would trunk the port as normal and do something like this:


>e.g Vlan - 1 to Vlan -5 has trunkport Gb eth 1/48
switchport trunk allowed vlan 1-5

>Vlan -21 trunkport Gb eth 2/2
switchport trunk allowed vlan 21

>Vlan-31 trunkport Gb eth 2/3
switchport trunk allowed vlan 31

[ssckrp]

Its a new testing requirement for a device.

Thanks and Regards